The SHERPA Power Base got an new update.
A overvew of the innovations:
Power Base C
Centre Point
The centre point is adjusted and screwed (new)
The simple design makes it easier to hammer in
Union Nut
The edge is chamfered, that gives a better appearence (new)
Drilling Baseplate
With the new Power Base, the dowel holes and the outer edges of the base plate are laser-cut, this leads to lower deformation of the material compared to the stamped predecessor. (new)
The edges of the plates are broken and not chatised. As a result, moisture that occurs can drain away or flow away unhindered and quickly.
Cone
With the new Power Base the cone is optimized and reduced.
The reduced cone allows a higher stability. (new)
Power Base F
Centre Point
The centre point is adjusted and screwed (new)
The simple design makes it easier to hammer in
Cap sleeve
The surface treatment of the cap sleeve has been increased in order to counteract any corrosion loads.
Top and Base Plate
With the new Power Base, the dowel holes and the outer edges of the upper part and the base plate are laser-cut
, this leads to lower deformation of the material compared to the stamped predecessor. (new)The edges of the plates are broken and not chatised. As a result, moisture that occurs can drain away or flow away unhindered and quickly.
to the SHOP